LSR Sealing Rings: Molding Precision and Leak-Test Requirements

Liquid Silicone Rubber (LSR) waterproof ring

A precisely molded LSR ring does not automatically make an assembled product waterproof. Define the ring geometry, material and mating assembly, then verify dimensional and sealing requirements through agreed tests.

Specify the Material and Dosing Package

Identify the exact LSR grade, component handling, supplier-specified mixing ratio, color or additive system and processing information. Do not apply a universal ratio or pigment precision claim to every material package.

Confirm the dosing, mixing and injection arrangement for the grade and intended shot. Record relevant checks and batch traceability. A mixing-system description is not evidence that every molded ring has reached the required cure or properties.

Review the Mold and Thermal Arrangement

Assess ring cross-section, critical sealing surfaces, parting line, gate, venting, cavity balance and any insert or bonding interface. Review the specified feed-path thermal management and mold cure conditions for the actual tooling.

A water-cooled nozzle or vacuum arrangement is not a universal requirement or a guarantee of defect-free production. Confirm the selected design, material behavior and trial results. Flash, filling and air-related defects need investigation of the complete process.

Establish Dimensions from Representative Parts

Define shrinkage and dimensional compensation using grade information and actual mold trials. Do not treat a fixed 2%–3% shrinkage range or a ±10°C temperature allowance as a general specification for all LSR rings.

State the cure and any specified post-processing or conditioning before measurement. Record cavity, batch, dimensions, visual findings and the conditions under which results were obtained.

Validate the Assembled Seal

Agree the mating surfaces, assembly method and compression conditions, together with the leak or ingress test method, exposure conditions and acceptance criteria. Keep any waterproof or protection claim attached to the tested assembly and scope. Ring dimensions alone cannot establish that result.

LSR Ring Questions

Can the Machine Guarantee Zero Flash or Leakage?

No. Verify the material, dosing, tooling, process, assembly and specified acceptance results together.

Can One Shrinkage Value Be Used for Every Grade and Geometry?

No. Use the actual material data and representative trial measurements, including the defined conditioning state.

See the LSR machine configuration guide, LSR process review and LSR product requirements checklist.

Related Illustration

LSR Liquid Silicone Rubber Injection Machine

The illustration is not a model-specific specification, approved service procedure or measured performance result.